Building/Construction

Step by step, this video presentation shows you what weight & balance is, why it is so important, how to calculate the numbers for your homeb...

Learn to make a perfectly fit and contoured coin or flush patch on a compound surface using only basic, non-powered hand tools the same standard ...

Video: Edge Those Panels With a hammer and dolly, or the edge of a workbench, many types of bends, flanges, and hems are shown, and common mistake...

Building an RV-12 has never been easier or faster! The construction manual supplied by Van's Aircraft is already accurate and complete. A builde...

With seven simple hand tools (including the torch), a set of wheel pants, or other similar panels can be constructed. This tape starts with alloy,...

This is a fly-on-the-wall style effort for those who want to watch a complete metal working process. Be the fly-on-the-wall as two metal guys, R...

Three EAA Technical Counselors (over 60 total years' experience) show you the procedures necessary to construct a complete airframe from plans. Ta...

Use, tune up, and modification to the Lancaster shrinking machines are demonstrated in depth in the first part, and then th...

If you want to learn how to handle, cut, drill, form and care for Plexiglas, then this is the film! Many experienced craftsmen have told me how mu...

Alan Laymon, owner of Solo Aviation, an authorized Rotax repair station with 10 years of experience with 2 cycle aircraft engines, e...

This fascinating look inside the airplane factories shows just how we produced over 330,000 aircraft in 4 1/2 years. Patterns, blanking, forming, ...

Shrink on the wheel? You bet! Analyze frame design, tracking patterns, layering, pressure measurement, rapid high crown development, nearly flat p...

A step by step video guide for building the rudder of a popular Vans RV aircraft kit Watching this video is the next best thing to a...

Also known as the Swift Polishing Video. This "how-to" film was done by the skilled folks at the Swift Airplane Museum. Polishing any aluminum can...