Cables and Connectors
MS27212-1-20 Terminal Strip
Stud thread: 6-32, last number indicates number of studs, MS27212 series terminal.
Lamar Connector KIT
Lamar Technologies Connector Kit
Thrust Aviation Tooling - Schrader Valve Charging Socket (Fits MS28889-2/9091C Valves)
This tool is the solution to service hard to reach Schrader valves, typical with many landing gear and accumulator configurations. Compatible with...
View full detailsTNC Female Connect RG 142 400
TNC Female Connect RG 142 400 Connector Jack Terminate To Coaxial Cable Crimp Type = Dual Coaxial Cable Termination Type = Crimp
SMA Connector AMX132134RP
SMA straight PCB Jack, through hole, 50 Ohm, reverse polarized. For use with Coax Cable RG400
SMA Male Crimp RG58
SMA and UHF Connectors.
TNC Right Angle RG 58
TNC Connector Right Angle Solder/Screw RG58
Cobra 1 BLK Acryl MNT 100 W/ Center Hole
Patented non slip strap retention. Acrylic best used on un painted surfaces of plastic or fiberglass.
Cobra CBL TS 4 18LB BLK 1000
Cobra® traditional style cable ties are UL and CSA approved with holding power 2x the rated specification.
Hellermann Tyton CTM410C2 Cable TIE Mount .25 100 Pack
Hellermann Tyton cable tie mounts are designed for use with 18 through 120 pound cable ties to provide stability when securing bundles. The moun...
View full detailsCobra 1 NAT Acryl MNT 100 W/ Center Hole
Patented non slip strap retention. Acrylic best used on un painted surfaces of plastic or fiberglass.
Bulkhead Seal SQ 1-3/8 ID Hole
Nylon Bulkhead seals are used when electrical harnesses or tubing is passed through bulkheads in pressurized and non- pressurized aircraft. Note: ...
View full detailsCobra 1 BLK Rubber MNT 100 W/ Center Hole
Patented non slip strap retention when threading vertically. Rubber pads best for general application on painted surfaces.
Cobra 3/4 NAT Acryl MNT 100 W/ Center Hole
Patented non slip strap retention. Acrylic best used on un painted surfaces of plastic or fiberglass.
Cobra CBL TS NAT 7.5 50LB 100
With an exceedingly low profile and a contoured locking head, the Cobra® configuration is safer, more flexible and stronger than existing cable ti...
View full detailsTy-D-Up RZP250 W/Black ZIP Ties
Ready-Zip-Pack is a portable solution for carrying zip ties in a handy ready to use fashion. Whether climbing a ladder, walking a line or in a t...
View full detailsMS27488-22-2 Sealing Plug
MS27488-22-2 - Connector Accessory, Sealing Plug, Circular Connectors. The MS27488-22-2 is a black grommet End Sealing Plug made of fluorinated ...
View full detailsDeklin Coil Cord - 18 Conductor
This aircraft grade 18 conductor coil cord is tested to the latest FAA Flame standards (14 CFR Part 25.869 (a)(4) Amdt 25-113 Appendix F Part I (a...
View full detailsCobra 3/4 BLK Acryl MNT 100 W/ Center Hole
Patented non slip strap retention. Acrylic best used on un painted surfaces of plastic or fiberglass.Dimensions: .75X5.75X7
Bulkhead Seal SQ 1-1/8 Hole
Nylon Bulkhead seals are used when electrical harnesses or tubing is passed through bulkheads in pressurized and non- pressurized aircraft. Note: ...
View full detailsCobra CBL TS BLK 14 120LB 100
With an exceedingly low profile and a contoured locking head, the Cobra® configuration is safer, more flexible and stronger than existing cable ti...
View full detailsCobra 3/4 NAT Rubber MNT 100 W/ Center Hole
Patented non slip strap retention when threading vertically. Rubber pads best for general application on painted surfaces.
23943 Alcor Connector Type K
Alcor by Tempest Connector Type K
Cobra 1 NAT Rubber MNT 100 W/ Center Hole
Patented non slip strap retention when threading vertically. Rubber pads best for general application on painted surfaces.