Engine Accessories

This heat shield is placed on exhaust where fuel lines, cable, etc. are close to exhaust and where heat...

These kits include new shaft & bearings. Kit for Cont. C-85, C-90, 0-200 Engine P/N 07-00110. Kit for Cont. C-145, 0-300 Engine P/N 07-...

Avglas STC, FAA-PMA repair kits for approved Continetal carburetor heat boxes are now manufactured by McFarlane Aviation. The Teledyne/Continental...

LYCOMING CHROME COMPRESSION RING - 74241Dimensions: .08X5.5X5.5

Avglas STC, FAA-PMA repair kits for approved Continetal carburetor heat boxes are now manufactured by McFarlane Aviation. The Teledyne/Continental...

This V-Belt has received FAA-PMA approval for a high quality V-Belt used on many Piper PA28 and PA32 aircraft. Direct replacement for s 1006...

Air-Tech Rotax Gear Box Clutch Bolt M10X16. 3 per clutch are needed.

Single Cylinder ring set for Continental Engine - For Steel Barrel Cylinders Only. OEM Part Number: 649632A1 Dimensions: 1X6.5X6.5

This V-Belt has received FAA-PMA approval for a high quality V-Belt used on many Piper aircraft.

Lycoming Camshaft Follower Tappet Assembly 15B28739 Part # 15B26091 superseded to part # 15B28739 Part # 71105 superseded to part # 15B26091 ...

Accepts 2 ducting on both ends. Helps route ducting through bulkheads, firewalls, etc. Especially useful for getting heat to the back seat of the ...

"Y" tube is designed to be used with the Homebuilders cabin heat box to make warm air available to 2 or more locations in the aircraft. Construct...

This part replaces Cessna 0750121. This intake Heat Shield Deflector is vibration dampened to prevent cracking! It is made of polished sta...

Lycoming piston pin (LW-13445) for 0-235 L, N Series.

Use this kit to repair an elongated hole in the carburetor heat box actuating arm. Kit comes complete with new bolt and attaching hardware made of...

Fuel flow to your aircraft's engine can be compromised by insects or debris entering fuel tank vents. This remove-before-flight Fuel Vent S...

This in-line valve connects to 2 SCAT ducting. It can be hooked up in any combination to direct air to either heater outlets or defrost outlets. ...

"Y" tube is designed to be used with the Homebuilders cabin heat box to make warm air available to 2 or more locations in the aircraft. Construct...

LYCOMING BEARING ROD - 69373

Sea Foam 16 oz. motor treatment for gas and diesel engines For use in gas, ethanol, diesel or biodiesel engines. Internal engine use on...

Continental Inner Valve Spring Used on C90 & O-200 Engines

This V-Belt has received FAA-PMA approval for a high quality V-Belt used on many Piper aircraft.

This heat shield is placed on exhaust where fuel lines, cable, etc. are close to exhaust and where heat...

For O-200 engine..............P/N 35145A-1For A-65,C-75,C-85 & C-90 engines...............................P/N 35145