Fuel Systems

Finger strainers are for fuel tank outlets. Standard size features a brass fitting with 3/8" male pipe thread which fits AN867-3 welding flange,...

SAF-AIR push type fuel drain valves are close tolerance valves of simple design. These valves provide the most trouble free operation of any other...

Install between fuel tank and engine. A few squeezes prime your engine for easy starting. For use with 1/4" ID hose. Dimensions: .5X2X2

FAA-PMA APPROVED Special electro polished shaft for longer o-ring life. McFarlane's blue Viton rubber tip will outlast the original in any f...

If you have electronic fuel injection, you should run a coarse pre-filter (FF-2, 90 micron) before the fuel pump, and a fine post filter (FF-1, 10...

Dimensions: 2X4.5X6.5

7031 Fuel Shut-off Valve. In Line Fuel Valve for fuel shut off. Ideal for use on panel to cut off fuel flow in a single line. All barbs...

A full-flow plug valve with solid bottom and integral mounting bracket. Brass body and plug. Floating stem with O-ring prevents leakage. Packed wi...

O-Rings for use with Usher Flush Fuel Caps.Dimensions: .25X1X1

Kit contains: Gasket and 3 O- Rings. Dimensions: .125X4X5

Citabria Fuel Vent Deflector.Dimensions: 3X4X6

P/S 890 Class B is an aircraft integral fuel tank sealant. It has a service temperature range from - 65°F (-54°C) to 250°F (121°C), with in...

Rhino 9700 is a 100% solids epoxy system which is the highest quality fuel and chemical resistant lining and coating material available. It contai...

Ideal for in-line fuel shut off. Handle indicates valve position. Hose barbs accept any 1/4" id fuel line. Must be used with clamps. . Brass Con...

The last one you will buy! Stainless steel No more corrosion pits or stripped threads Costs less! Dimensions: .5X.5X3.5

For use with SPRL fuel valves V1, V2, and V3 14mm X 3" FITTINGDimensions: .75X4.5X4.75

Perfect for feeding from 2 tanks, or for feeding two carburetors from 1 tank. All have standard barbed ends. Made of Delrin. Note: Fits lines wi...

SAF-AIR designed its line of flush mounted fuel drain valves to be an exact replacement for the Auto Valve F391 line of flush fuel...

SAF-AIR Products, Inc. has taken its very dependable fuel drain valve and added a new feature it locks in the open position! This valve makes the...

Matches Aero aluminum fuel caps.Dimensions: .75X.75X3.5

This cap has secure sealing and easy finger tip operation. These caps are made from the highest quality modern engineering plastics with Viton o r...

Built from aircraft grade Aluminum and anodized for corrosion protection this lightweight and compact unit is excellent. The check valve is ideal ...

**This is a very fine stainless steel type filter. Frequent inspections are required.** This award winning high performance b...

Now FAA TSO-C76 Approved.Brass Fuel Valves, Push to Open, Non-Lock Open, Use Pin Type Cup. Use Curtis Drain Cup - CCA-39680. Curtis Superior Va...