Hardware

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

When there is a gap between the top and bottom panels, a retaining spring is used to hold the stud in locking position for alignment with receptacle.

Made of alloy steel per specification MIL-P-5673 and cadmium plated per QQ-P-416A, Type lI, Class 3. Provided with drilled hole for cotter...

Offset Cruciform 100 Deg Flush Head Material - Alloy Steel (8740) or Cres. (A-286) Heat Treat - 160,000 - 180,000 PSI or 160,000 - 190,000 P...

These pan head machine screws feature 60,000 psi min. tensile strength & are cadmium plated to specification QQ- P-416, Type 2, Class 3. Manuf...

AN526-832R32 Type B, Phillips

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Factory New Lycoming Bolts.

AN Nut Couplings

2700 STUD LENGTH SELECTION Total material thickness G consists of the thickness of all materials to be fastened. This must include the thickness ...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Use screws for all panel installations to eliminate magnetic interference. Finish: Black Oxide

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless gro...

Phillips 82° Flat Head Stainless Steel

CLoc® 4000 Series Grommets - Stainless Steel- TSO-C148 Approved.

(A, B, L dimensions for AJW are same as for AJ; P, Q, R dimensions given are for wing head) CAD PLATED FASTENERS ARE NO LONGER AVAILABLE DUE TO ...

CLoc® 2000 & 4000 Series Fastener Installation Tool

Truss-head non-structural machine screws made of carbon steel, cadmium plated. Minimum tensile strength 55,000 PSI. Available in slot head or Phi...

Provide efficient locking action by spring tension and biting action of tapered twisted teeth. Made of 1050 spring steel and cadmium plated per sp...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

MS20073/MS20074 Engine Bolts

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

Phillips pan head 300 Series stainless steel Finish - Passivate per QQ-P-35