Hardware

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Knurled for ease of application, Series CD caps seal flared JIC fittings exceptionally well against dirt and moisture, as well...

AN565 Set Screws

High-strength machine screws fabricated from alloy steel per specification QQ-S-689. Tensile strength 125,000 PSI. Cadmium plated per QQ-P-416A,...

NAS6603 Shear BoltsThread 10-32

Taper pin washers are used with AN386 threaded taper pins. Manufactured of steel, cadmium plated.

Kit contains Southco or Camloc studs, washers, retainers & a push tool for the Southco studs. Receptacles for Camloc or Southco fasteners are ...

PLUG AND BLEEDER, Screw Thread

Phillips Hex Head Alloy Steel per MIL-S-6049 Finish - Cadmium per QQ-P-416 Type II Tensile - 125,000 - 145,000 PSI

Clevis bolts have a slotted brazier type head. They are special-purpose bolts for use where a large shearing stress occurs (never in tension). M...

"A" rivets are "soft". They are fabricated from 1100-grade aluminum and have a tensile strength of 16,000 PSI. "AD" rivets are fabricated from 211...

Made of alloy steel per specification MIL-P-5673 and cadmium plated per QQ-P-416A, Type lI, Class 3. Provided with drilled hole for cotter...

MS21043 Hex Nut, often referred to as jet nuts or reduced hex nuts. Less 20% for quantity 100/Part No.

MIL-SPEC designations for flat washers, NAS620. Covered by military procurement specification FF-W-92 which has, as minimum requirements. 1.Chemic...

Installation hole size for the A-T Series Insert is determined by the parent material's thickness and density. The thicker the material the larger...

Snaps over edge of panels or into center hole locations. Holds itself in place for blind assembly. "Floats" free for easy hole al...

Use with 100° flat head screws to provide reinforced, low-profile attachments. Less 20% Discount o...

Due to the large bulbed blind head, similar to a solid rivet, the Cherrylock and CherryMax rivets are especially suited for double dimpled or high...

High-strength machine screws fabricated from alloy steel per specification QQ-S-689. Tensile strength 125,000 PSI. Cadmium plated per QQ-P-416A,...

CESSNA BOLT NAS464P3-8 Material: Plated Shank Dash Number: -3 Thread Dia/Pitch: 10-32 Wrench Size: 3/8" Grip Length: .344 Nominal Leng...

MS24665 cotter pins are stocked in cadmium plated steel (formerly AN380) in the priced sizes listed above. Other sizes available on special order....

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

AN960 flat washers are used under hex nuts to provide a smooth bearing surface, as shims to obtain the correct grip length for a bolt an...