Hardware

Hose and tubing Insert Fittings are available in high density Black Polyethylene or White Nylon. Use polyethylene fittings with Tygon, n...

Series PD Plugs, designed for use on flared JIC fittings, air knurled for ease of application. They will seal low pressu...

Made of alloy steel per specification MIL-P-5673 and cadmium plated per QQ-P-416A, Type lI, Class 3. Provided with drilled hole for cotter...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

AN822 (MS20822) ELBOW, Flared Tube and Pipe Thread, 90°

These structural screws have a 100° countersunk head. Cadmium plated per QQ-P-416A, Type II, Class 3. Minimum tensile strength for steel is 125,...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Brass compression fittings to be used with standard or high pressure NSR hose.

Nylo-Seal tube fittings are exceptionally strong. The bodies, made of nylon, are stronger than machined fittings of similar composition. They are ...

Snaps over edge of panels or into center hole locations. Holds itself in place for blind assembly. "Floats" free for easy hole al...

Stainless Steel Stop Nut

These non-structural screws have a flat countersunk head, 100° cross recessed head. (-C #'s) Cleaned and descaled, corrosion restistant ste...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

P60458 Steel Rivet - Steel Mandrel. 3/16 diameter x 3/8 head x 3/8 to 1/2 range. Blind open end pop rivets are available in a variety of sizes, ty...

Truss-head non-structural machine screws made of carbon steel, cadmium plated. Minimum tensile strength 55,000 PSI. Available in slot head or Phi...

Elbow, Flared Tube, 90°

These structural screws have a 100° countersunk head. Cadmium plated per QQ-P-416A, Type II, Class 3. Minimum tensile strength for steel is 125,...

The AN363 all-metal stop nuts are designed for use in high temp installations (up to 450°F). Fabricated from cadmium plated per spec...

"A" rivets are "soft". They are fabricated from 1100-grade aluminum and have a tensile strength of 16,000 PSI. "AD" rivets are fabricated from 211...

Tapered Caplugs can be used as either caps or plugs. Because they are tapered in design and made from highly pliable (or...

Phillips Hex Head Alloy Steel per MIL-S-6049 Finish - Cadmium per QQ-P-416 Type II Tensile - 160,000 - 185,000 PSI

MS24665 cotter pins are stocked in passivated corrosion resisting stainless steel (formerly AN381) in the priced sizes listed above. Other sizes a...

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

Phillips pan head 300 Series stainless steel Finish - Passivate per QQ-P-35