Hardware

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

ALUMINUM WELDING FLANGESDimensions: .75X1.875X1.875

NAS517-2-1 Alloy Screw

Series PD Plugs, designed for use on flared JIC fittings, air knurled for ease of application. They will seal low pressu...

These non-structural screws have a flat countersunk head, 100° cross recessed head. (-C #'s) Cleaned and descaled, corrosion restistant ste...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Phillips Pan Head Alloy Steel per MIL-S-6049 Finish - Cadmium per QQ-P-416 Type II Tensile - 160,000 - 180,000 PSI

These pan head low alloy steel machine screws have 125,000 to 145,000 psi tensile strength w/cadmium plate finish to QQ-P-416, Type 2, Class 3. MS...

Oillite bronze bushings are highly heat resistant, ductile, conformable and corrosion resistant.

Truss Head Type A Stainless

Clevis bolts have a slotted brazier type head. They are special-purpose bolts for use where a large shearing stress occurs (never in tension). M...

Stainless Steel Stop Nut

Clevis bolts have a slotted brazier type head. They are special-purpose bolts for use where a large shearing stress occurs (never in tension). M...

Truss-head non-structural machine screws made of carbon steel, cadmium plated. Minimum tensile strength 55,000 PSI. Available in slot head or Phi...

Series RCL caps are ideal for protecting threaded or smooth cylindrical surfaces. Originally designed for ...

All s will follow this format: AN###. To further distinguish between the s, you'll notice that a dash ("-") has been added, followed by some sp...

MS24665 cotter pins are stocked in cadmium plated steel (formerly AN380) in the priced sizes listed above. Other sizes available on special order....

Manufactured from alloy steel, minimum tensile strength 125,000 PSI. Cadmium plated. Taper: 0.500"/ft. Use with AN975 taper pin washer, AN320 shea...

NIPPLE, Flared Tube and Pipe Thread

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Type: NAS387 Material: Carbon Steel Type 1016 - 1024 Finish: Nickel Plate (PDF)

"A" rivets are "soft". They are fabricated from 1100-grade aluminum and have a tensile strength of 16,000 PSI. "AD" rivets are fabricated from 211...

Use screws for all panel installations to eliminate magnetic interference. Finish: Black Oxide Drive Type: Phillips

These pan head machine screws have 55,000 psi minimum tensile strength and are cadmium plated to Specification QQ-P-416, Type 2, Class 3. Manufa...