Hardware

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

Eye bolts are special purpose bolts to be used where external tension loads are to be applied. The eye is designed for attachment of such devic...

MIL-SPEC designations for flat washers, NAS620. Covered by military procurement specification FF-W-92 which has, as minimum requirements. 1.Chemic...

Monadnock Clip Nut 6-32, 294667

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

Installation hole size for the A-T Series Insert is determined by the parent material's thickness and density. The thicker the material the larger...

Factory New Lycoming Bolts.

Individual airplane exterior screw kit. This kit does not include any structural screws. This kit does not include any structural screws.

These pan head low alloy steel machine screws have 125,000 to 145,000 psi tensile strength w/cadmium plate finish to QQ-P-416, Type 2, Class 3. MS...

Offering corrosion resistance, strength, and rigidity, these standard-wall PVC fittings are the most common choice for plastic fittings in lowpres...

NAS6603 Shear BoltsThread 10-32

Type: Stud

Wire clamps for solid wire controls for Cessna Aircraft. Wire clamps are used on solid wire controls including cabin air, mixture control, strain...

Stainless Steel Stop Nut

Eye bolts are special purpose bolts to be used where external tension loads are to be applied. The eye is designed for attachment of such devic...

Phillips Pan Head Alloy Steel (8740) Finish - Cadmium per QQ-P-416 Tensile - 160,000 - 180,000 PSI

All s will follow this format: AN###. To further distinguish between the s, you'll notice that a dash ("-") has been added, followed by some ...

Coarse Thread - Use brass type for instruments AN340 CAD-PLATED (MS35649) AN340C STAINLESS (MS35649) AN340B BRASS (MS35649) AN340 COARSE...

Phillips pan head 300 Series stainless steel Finish - Passivate per QQ-P-35

Used to replace threaded nuts, lock washers, and spanner washers; weigh less than other types of self-locking aircraft fasteners. Can be applied f...

Hardened steel screws to make permanent fastenings to ferrous and non-ferrous castings, heavy gauge steel,...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

These non-structural screws have a flat countersunk head, 100° cross recessed head. (-C #'s) Cleaned and descaled, corrosion restistant ste...