Hardware

These non-structural screws have a flat countersunk head, 100° cross recessed head. (-C #'s) Cleaned and descaled, corrosion restistant ste...

Phillips pan head 300 Series stainless steel Finish - Passivate per QQ-P-35

Truss-head non-structural machine screws made of carbon steel, cadmium plated. Minimum tensile strength 55,000 PSI. Available in slot head or Phi...

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

Type: Stud

These structural screws have a 100° countersunk head. Cadmium plated per QQ-P-416A, Type II, Class 3. Minimum tensile strength for steel is 125,...

Nylo-Seal tube fittings are exceptionally strong. The bodies, made of nylon, are stronger than machined fittings of similar composition. They are ...

Pan head low alloy steel machine screws have 125,000 to 145,000 psi tensile strength with cadmium plate finish to QQP416, Type 2, Class 3. MS27039...

Cage type. Permit mounting of aircraft instruments from the front of the panel. No charge in panel or instrument design required. Non-magnetic (s...

Factory New Lycoming Bolts.

CLoc® 4000 Series Grommets - Stainless Steel- TSO-C148 Approved.

To select the proper length stud, first select the grommet, for example 4002-G. Next, select the receptacle, such as 214-16. Afte...

NAS6603 Shear BoltsThread 10-32

2700 STUD LENGTH SELECTION Total material thickness G consists of the thickness of all materials to be fastened. This must include the thickness ...

Made of alloy steel per specification MIL-P-5673 and cadmium plated per QQ-P-416A, Type lI, Class 3. Provided with drilled hole for cotter...

These structural screws have a 100° countersunk head. Cadmium plated per QQ-P-416A, Type II, Class 3. Minimum tensile strength for steel is 125,...

2700 STUD LENGTH SELECTION Total material thickness G consists of the thickness of all materials to be fastened. This must include the thickness ...

Note: quantities must be entered in decimal format. (i.e. 0.25 for 1/4, 0.50 for 1/2, etc). Minimum Purchase 1/8 lb. (qty .13). "A" rivets are "so...

Phillips 82° Flat Head Stainless Steel

These structural screws have a 100° countersunk head. Cadmium plated per QQ-P-416A, Type II, Class 3. Minimum tensile strength for steel is 125,...

Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground...

"A" rivets are "soft". They are fabricated from 1100-grade aluminum and have a tensile strength of 16,000 PSI. "AD" rivets are fabricated from 211...

These brass elbows and tees provide flexibility in the routing of lines which terminate in male pipe threads.

Manufactured from alloy steel, minimum tensile strength 125,000 PSI. Cadmium plated. Taper: 0.500"/ft. Use with AN975 taper pin washer, AN320 shea...