Tanis STC Engine Preheat KIT - 6 Cylinder Continental Lycoming AND Franklin - 115 Volt #SE03309CH..ALSO Tcca & Easa Approved TSP6CYL-2927-115

This preheat kit contains threaded heat elements located in each cylinder assembly, (intake bolt or rocker cover screw replacement) and two pad heat elements for the engine crankcase/oil sump/oil tank. This multipoint configuration fully preheats the engine and attached accessories. Power is routed to the elements through a dedicated wiring assembly with LED system power indication and circuit overload protection standard. The system is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.

This preheat kit is compatible with all engine monitor systems as the threaded heat elements can replace either a rocker cover screw or intake bolt fasteners.

This preheat kit when installed will supply 460 watts with a 4.0 amp draw at 115 volts (Standard North American wall voltage).

TCCA acceptance of FAA-STC on file

* Required Bonding sealant sold separately. Quantity 1, PN: TAU02788

Not eligible for Rotorwing aircraft (helicopters).

Dimensions: 4X10X14