Tekton - 1/4 Inch Drive X 5 Inch Aluminum Spinner Handle With Drive Square (1 Inch Shank)

6.5 Inch Steel Extension with Aluminum Handle

This spinner handle is made of a 5 inch steel extension that runs all the way through an aluminum handle and is permanently pressed in place.
The tri-lobe shape feels secure in your hand and keeps it from rolling on surfaces, while the rounded knurled sections make it easy to spin quickly. The exposed shank is 1 inch long, and the square drive in the end of the handle lets you add a ratchet for more leverage.

1/4 Inch Drive Square in the Handle
Add a ratchet for extra leverage without removing the socket from the spinner handle. Break the fastener loose, pull the ratchet off, and spin it out by hand. Swap in a torque wrench when it's time to tighten to spec.

Coarse Knurling and Rounded Areas for Better Grip and Faster Spinning
A deep, sharp-cut diamond pattern is knurled into the rounded sections at the front and back of the handle to create a coarse, non-slip texture.

Tri-Lobe Shape for More Torque and Roll Resistance
The handle's three-sided geometry gives you the leverage to apply higher turning force by hand while also keeping it from rolling on flat surfaces.

2.5 Inch Shank for More Reach
The exposed shank is 2.5 inches long to extend your reach into tight spaces.

Secure Drive Engagement
Sockets and accessories are held onto the shank by a spring-actuated detent ball.

Materials and Assembly

A 5 inch steel extension runs all the way through an aluminum handle and is permanently pressed in place. Two "wings" on the shaft of the extension prevent it from being twisted or pulled out of the handle.
A. Extension: 50BV30 chromium-vanadium steel with a chrome-plated finish
B. Handle: 6061 aluminum with a matte black anodized finish

Dimensions: 1X2X6