Cable Assemblies

These copper stop sleeves are used on the ends of bare cables. When properly applied with Locoloc® Hand Swager to bare cable on 3x7, 7x7, 7x19 ...

Dimensions: .3125X.3125X.875

Clip-Locking Turnbuckles utilize 2 locking clips instead of lock-wire for safety. The turnbuckle barrel and terminals are slotted lengthwise to...

Dimensions: .18X.18X2.61

These rods ends are machined from 1035 or 1042 carbon steel and cadmium plated. Minimum tensile strength 65,000 PSI. They are inter...

These control cables are pre-stretched for closer tolerance applications and to reduce stretching following installation. The major difference bet...

Nylon construction for external use. Two halves with retaining clip. P/N 05-05500 is 3/4" OD X 3/4" long x 1/2" ID to fit materi...

Oval shaped copper sleeves used in making eye or lap splices in flexible cable. Sleeves are slipped over the two strands of cable to be fastened a...

Clip-Locking Turnbuckles utilize 2 locking clips instead of lock-wire for safety. The turnbuckle barrel and terminals are slotted lengthwise to...

The MS21259 series stud end fittings are manufactured from stainless steel to the strict standards of MS21259. They are certified to the MS21259 s...

The major difference between aircraft and commercial cable is the lubrication applied to aircraft cable, which provides substantially b...

Clip-Locking Turnbuckles utilize 2 locking clips instead of lock-wire for safety. The turnbuckle barrel and terminals are slotted lengthwise to...

The major difference between aircraft and commercial cable is the lubrication applied to aircraft cable, which provides substantially b...

The "R" or "L" following the dash number designates "right" or "Left." The "S" or "L" (2nd letter following dash number) indicates "short" or "lo...

Clip-Locking Turnbuckles utilize 2 locking clips instead of lock-wire for safety. The turnbuckle barrel and terminals are slotted lengthwise to...

These terminal assemblies include the AN665 terminals plus the appropriate lock nut, clevis pin, and cotter pin.

The "R" or "L" following the dash number designates "right" or "Left." The "S" or "L" (2nd letter following dash number) indicates "short" or...

The "R" or "L" following the dash number designates "right" or "Left." The "S" or "L" (2nd letter following dash number) indicates "short" or "lo...

Complete turnbuckle assemblies consist of a brass barrel and two steel ends, one with right-hand thread and the other with left-hand thread....

The "R" or "L" following the dash number designates "right" or "Left." The "S" or "L" (2nd letter following dash number) indicates "short" or...

These control cables are pre-stretched for closer tolerance applications and to reduce stretching following installation. The major difference bet...

These control cables are pre-stretched for closer tolerance applications and to reduce stretching following installation. The major difference bet...

The "R" or "L" following the dash number designates "right" or "Left." The "S" or "L" (2nd letter following dash number) indicates "short" or...

Clip-Locking Turnbuckles utilize 2 locking clips instead of lock-wire for safety. The turnbuckle barrel and terminals are slotted lengthwise to...