Probes And Senders

Insight is the world's largest manufacturer of aviation temperature probes. The temperature probe measures the engine's pulse and therefo...

Probe PN 400509 is a complete assembly using type K thermocouple wire (red/yellow). The sensor port is a standard 5/8-18 thread for bot...

Alcor 98214 K Type Thermocouple Wire. 22 awg, 7/30 stranded insulated with FEP. Sold in 50 ft packs.

**Note: Cessna probe CHT S2334-3 (06-00703) must be used with the new rochester gauges. Cannot be used with old Stewart Warner gauges.Dimensions:...

Hard tank fuel probe mount kit.Dimensions: 2X4X4

RPM Sensor for BENDIX Series.

Secondary TIT or Oil Temp probe, 7/16-20 thread adjustable depth and 6ft cable.Dimensions: 1.125X5.5X8

Since Bayonet CHTs are made with short length leads, extending them is often necessary. CHTs and EGTs should be extended with type-K extension w...

ISS carb fuel pressure sender, 16PSI, Non-TSO.Dimensions: 2X2X3

For reliability and durability reasons, E.I. will only manufacture ungrounded EGT probes. Ground noise at the engine can be a big problem...

The Turbine Inlet temperature (TIT) probe, is installed in the exhaust stack accumulator to a maximum depth of 1/2 inches and approximately 2-4 in...

MGL Avionics Type-K EGT Thermocouple Clamp - Type small. 1.5 Dia. Probe dia. approx 0.198"Dimensions: .5X3.5X6.5

1/8 NPT with adjustable depth. (with cable)

ISS Oil Temperature Sender with 240° - Non-TSO 3/8 diameter 1/8 NPT thread Dimensions: .5X.5X2

Single-station senders for water and oil temperature gauges. Range: 100-280°F & 140-320°F Thread: 1/8-27 NPTFDimensions: .5X.5X2

Alcor EGT/TIT Probe Grounded, .70 OHM, Type K 7/16. PMA/FAA approved.Dimensions: 1X2X7

Oil Temp Probe - For Lycoming and Continental engines for use with older GRT EIS models with software versions beginning with 44S--- or 66S---. Pl...

Superior to any other type of pyrometer available. Unlike com­pet­ing brands, these units are temperature com­pen­sat­ed. That is, wh...

ALCOR EGT/TIT PROBE GROUNDED, .80 OHM, TYPE K 7/16 * All ring terminals and hardware Dimensions: .5X2.5X6

The Fuel Pressure injected engine 5-32 psi, 1/8 NPT is mounted to the pressure line using a 6 inch flexible hose and fittings (not supplied). Y...

C223 CHT Sender 14mm. Imported From China.Dimensions: 1X4X4

**Note: Cessna probe CHT S2334-3 (06-00703) must be used with the new rochester gauges. Cannot be used with old Stewart Warner gauges.Dimensions:...

ISS fuel pressure sender, injected 60PSI, non TSO.Dimensions: 3X3X3.5

Skysports Metal Sleeve CHT ProbeDimensions: 1X4X4