Probes And Senders
Filters
Fuel Probe 12V 24IN 3BND 0-5V
The probe is constructed of concentric tubing (a small tube inside a larger tube). The tubes, which are separated by small insulators to keep the...
View full detailsJPI EDM Option RPM With NEW Install Only P3 Harness Included
When ordering please specify: -Aircraft Make -Aircraft Model -Engine No. -Pressurized (Yes/No) -Magneto Type (Bendix/Slick) -Magneto Model -...
View full detailsInsight G3 OIL Temp Probe 5/8 18
K-Type thermocouple Red/Yellow in Yellow. "Supplementary Only" Not Primary
JPI EDM 900 Series P-3 MAP RPM OIL Press Harness 790422
JPI EDM 900 Series P-3 MAP RPM Oil Press Harness 790422
Mitchell Pres Sender 15 30 PSI
Gauge Range: 15/30 PSI FAA-PMA # Terminals: 2 Notes: Units with one terminal require the mount be grounded. Units with two terminals require ...
View full detailsMitchell Wire KIT Conn 3 Term
Mitchell Wiring Kit Gauge Connector PS-211-8018
Cies Digital Sender FOR Piper PA24 /PA30/PA39 SET OF 4
Each kit includes all necessary senders for the selected aircraft. A better way to measure fuel. This Magnetic Field Sensor technology is paten...
View full detailsJPI Replacement RPM Sensor FOR Dual Bendix MAG
RPM Sensor for BENDIX Series.
GRT OIL Temp Probe
Oil Temp Probe (Lycoming/Continental, single wire) For Lycoming and Continental for use with newer EIS models with software versions beginning w...
View full detailsJPI Option Induction AIR Probe IAT
The Induction Air Temperature (IAT) probe, is installed just after after the inter-cooler. The probe is installed with a #40 stainless steel clamp...
View full detailsUMA J Type CHT 10MM Spark Plug Probe 6 Lead NON TSO
Type J CHT probes 10-18mm spark plug ring. Made in the USA.
Fuel Probe 12V 24 Inch 05 V
The probe is constructed of concentric tubing (a small tube inside a larger tube). The tubes, which are separated by small insulators to keep the...
View full detailsUMA K Type EGT 1 - 2 Clamp Probe 6 Lead NON TSO
UMA 2-1/4" type K EGT probes. Range: 700-1700F. Made in USA.Dimensions: 1X2.25X5
IM-927 EGT Type K Sensor 6FT
Probe for the measurement of the temperature of exhaust (EGT) for all ROTAX engines. It has a thread metric 8 and it can be installed directly on ...
View full detailsSwift Fuel Sender 24 Bendable 1/8 NPT W/ Alarm 0-5V Output
Note: Photo for general reference only. Actual sender may differ in appearance. Swift Fuel capacity sender ...
View full detailsWestach Electronic Pressure Sender 100 PSI 1/8 NPT NON TSO
0-100 psi, 1/8" npt, stainless steel diaphram works on 5 vdc from gauge, .5 to 4.5 vdc output Made in USADimensions: 1X4X4
Swift Fuel Sender 18 Bendable FM W/ Alarm 0-5V Output
Note: Photo for general reference only. Actual sender may differ in appearance. Swift Fuel capacity sender ...
View full detailsProbe EGT 1/4 NPT
Superior to any other type of pyrometer available. Unlike competing brands, these units are temperature compensated. That is, wh...
View full detailsSwift OIL / Water Temp Sender 1/8 NPT 1/4 TIP
Swift Oil Temperature Sender 1/8" Pipe Type. Similar to Falcon Gauge Made in China Dimensions: .5X2.5X3.5
VDO Fuel Sender Mounting KIT Fits 5 Hole Senders 226-451
VDO Fuel Installation Kit: Fuel probe mounting ringDimensions: 1X5X17.5
Alcor K Type EGT 1-1/8 - 3-3/8 Clamp Probe 86281 PMA
ALCOR CLAMP 3-1/4 EGT/TIT PROBE GROUNDED, .85 OHM, TYPE K
GRT Outside AIR Temp Probe FOR EIS OR Efis
Grand Rapids Technology OAT-003 for use with Grand Rapids EIS 2000, 4000, 6000.
Cies Digital Sender FOR Cessna 172/175
Each kit includes all necessary senders for the selected aircraft. A better way to measure fuel. This Magnetic Field Sensor technology is paten...
View full detailsJPI M-111-TT Screw IN Style TIT Probe
The Turbine Inlet temperature (TIT) probe, Screw-in type with 7/16-20 thread.